We all know that working at heights is a high-risk job. A slight carelessness poses a serious threat to life safety. Now, high-altitude trucks are a common tool for assisting work at high altitudes. Therefore, the precautions during use of high-altitude vehicles are particularly important. Only by understanding the attention of aerial vehicles can reduce the probability of potential hazards of aerial vehicles . Then what are the precautions for use of aerial vehicles ? Before using high-altitude vehicles , be sure to carefully read the use of the car and pay attention to the technical parameters of the car inside the manual. Pre-use inspection is a very important aspect, the use of high-altitude vehicles must check the power balance Whether the electrical switch has disengaged the force gear from the car gear. In order to prevent damage to the boom, it is necessary to pay attention to putting the boom fully in place before working at heights. It is best to tie it up with a strap, not to let it hang, and to tighten the leg. It is also necessary to check and maintain the car in accordance with the regulations before use. During the operation and inspection, we must pay attention to whether the high-altitude operation vehicle meets the normal working conditions in the manual. It is also necessary to check whether the various components in the vehicle are firm. The looseness of one component causes serious personal injury and each component is in use. Lubrication is required during this period. It is also necessary to check whether the hydraulic oil in the work vehicle is sufficient. The oil valve is not in the open state. It is also a very important step to check if the engine is normal. We must extend the legs horizontally during the leg operation, then straighten the legs vertically, and then first need to shrink the legs vertically and then shrink the legs horizontally before lowering the leg. When operating the aerial vehicle, we must first When you get off the train and get on the train, you need to pick up the car and then close the car after the job is over. When performing boom work, it is necessary to raise the upper arm to lower the arm. The precautions for aerial work vehicles play a very important role in the personal safety of operators and high-altitude workers. Therefore, we must understand all aspects so that we can operate the machine skillfully. Nitrogen Generator For Heat Treatment Nitrogen Generator For Heat Treatment,Industry Nitrogen Generator,Nitrogen Generator Installations,Nitrogen Psa Generators Laser Cutting Jiangsu Minnuo Group Co.,Ltd , https://www.mnuogroupcn.com