The main parts of the eccentric bushings should be repaired and replaced if they are used to the following extent: (1) If the outer circle of the eccentric bushing wears more than 3.0mm, it should be replaced; (2) The clearance between the straight bushing and the eccentric bushing exceeds twice the original assembly clearance (see Table 1); the straight sleeve has cracks, which exceeds l/3 circumference or height. If one of the above is used, the straight sleeve should be replaced; (3) The gap between the taper sleeve and the upper part of the main shaft, which is more than double the original assembly clearance (see Table 1) or severe cracks should be replaced; (4) If the tooth thickness of the conical large gear is more than 20%, it shall be replaced; (5) The lower end thrust bearing pad of the eccentric bushing shall be replaced if the wear non-parallel deviation exceeds 0.1 mm or the thickness wears more than 5.0 mm. Table 1 Bushing assembly clearance specification Gap position 900 1200 1750 2100 2200 Rack bushing clearance / mm 2±0.38 2 4 2 4±0.3 Cone sleeve upper clearance / mm 3.2 2 3 3 3.1 Cone sleeve lower clearance / mm 10 9.5 8.5 10 10 Vibrating Sieve,Circular Vibrating Sifter,Rotary Vibro Screen,Rotation Vibrating Screen Changzhou Bole Tech Co.,Ltd , https://www.boledrying.com