Gantry Double Plasma Cutting Machine
We are involved in offering high-quality CNC Plasma Cutting Machine to our valuable customers. These products are made from high-quality components.Our company are prominent manufacturers and exporters of high-quality Auto Duct Forming and Cut to Length Machines. Offered products range consists of Auto Duct Forming Machine, Cut to Length Machine and Roll Former Machine. All offered products are manufactured under the direction of experts using quality tested material and latest technology as per industry norms. Sturdy designs, fine finish, high strength, long service life and damage resistance are features of our offered range of products.
Gantry
double plasma CNC cutting machine is a stereotyped product carefully developed
by our company. It has high processing efficiency and is 2.2 times of single
gun cutting. It is a numerical control equipment for metal sheet blanking. It
not only has an appearance atmosphere, but also has stable operation, high work
efficiency and long service life. It can realize cutting of any metal material
according to any pattern. It is widely used in the cutting of sheet metal in
various mechanical manufacture industry.
Type
BLDS-3060
BLDS-4080
BLDS-5080
BLDS-60100
BLDS-80100
Input power
AC380V/50Hz; AC220V/50Hz
Track gauge(mm)
3000
4035
5000
6000
8000
Effective
cutting width(mm)
2300
3300
4300
5300
7300
Machine
width(mm)
3500
4300
5500
6500
8500
Track length(mm)
6000
8000
8000
10000
10000
Number of cutting torch(set)
2
2
2
2
2
Lift(mm)
200
Cutting thickness(mm)
1~30(According to the power supply size)
Cutting speed (mm/min)
450~5000
Idle speed(mm/min)
0~8000
Drive mode
Bilateral drive
System
Shanghai Jiaoda or Beijing Starfire
Operating accurancy
±0.5mm
Cnc Plasma Cutting Machine,Cnc Full Mato Cutting Machine,Gantry Double Plasma Cnc Cutting Machine,Double Plasma Cnc Cutting Machine Shandong Buluoer Intelligent Technology Co., Ltd. , https://www.buluoercuttingmachine.com
Flange butterfly valve leakage problem solution
Flange butterfly valve leakage problems: In the screw conveyor to the reactor with powder feeding the lower tube installed a pneumatic butterfly valve, the reaction process will be part of the solvent (acetone) evaporation back. If the butterfly valve leakage, that is, increase solvent loss, but also easy to make the powder material in the material caking, clogging pipes. Flange butterfly valve to solve the problem: the fundamental reason for the butterfly valve leakage is the selection problem. Sealing materials from the butterfly valve inside the form is divided into soft seal and hard seal. If dust caking can not be avoided, other types of valves should be considered. Test flexible flange butterfly valve, the pressure ring this side up flat, placed in this plane and a flange outside the park, the valve through the same size of the plate, if the test press, the pressure to be pressed This pressure plate, so that the pressure evenly distributed on the pressure ring on the side of the body. If it is to use blind test, the general butterfly valve flange are used to clamp two flanges for clamping test, flange flexible flange butterfly valve sometimes, only for the convenience of the user with a flange below And the valve bolt fixed, then the body of the pressure ring above the fixed screw to withstand the full pressure of the medium, as mentioned earlier, these few screws can not withstand the pressure of all the media, so with a blind Test valve does not leak, but also the same as the actual state base.